In rainy seasons, the board of the Visual-Tex DTF Printer is easy to be affected with moisture. If the board of the Visual-Tex DTF Printer is affected with moisture for a long time, it is easy to cause board corrosion and component damage. In serious cases, it may also lead to short circuit, which will directly burn the board or other important accessories. Therefore, we must pay attention to the phenomenon of damp of the board of the Visual-Tex DTF Printer.

So what if the Visual-Tex DTF Printer board gets wet?

When we find that the board of the Visual-Tex DTF Printer is damp, we should not continue to start up and use it as usual. What we need to do is to take the board off the machine and dry it. After drying, check whether all functions are normal and use it after confirming that it is normal and has no potential safety hazards.

In order to prevent the board of the Visual-Tex DTF Printer from getting wet, we need to control the humidity of the working environment of the Visual-Tex DTF Printer below 60%, which is also part of the daily maintenance of the Visual-Tex DTF Printer operator. If the board gets wet due to negligence, it should be handled in time to minimize the loss.
Visual-Tex VT300

Zhengzhou Visual-Tex used advanced and practical technology to design and produce wide format printer, DTF printer direct to film printer, digital sublimation printer, eco solvent printer and UV printer and other mature products, which are well known in the national photo machine industry. the products are exported to Europe, America, South America, Southeast Asia, the middle east and Africa, and in many countries and regions around the world to establish a distribution network and service system.